2004款丰田卡罗拉自动变速器系统维修手册(英文版) 40–1 AUTOMATIC TRANSMISSION TRANS – AUTOMATIC TRANSAXLE ASSY ATM AUTOMATIC TRANSAXLE ASSY ATM 400LF–01 PRECAUTION 1 The automatic transaxle posed of highly precision–finished parts necessitating careful inspection before reassembly because even a small nick could cause fluid leakage or affect the performance The instructions here anized so that you work on only ponent group at a time This will help avoid confusion from similar–looking parts of different sub–as- semblies being on your workbench at the same time ponent groups are inspected and repaired from the converter housing side As much as plete the inspection repair and reassembly before proceeding to the ponent group If a defect is found in a certain component group during reassembly inspect and repair this group immediately If po- nent group cannot be assembled because parts are being ordered be sure to keep all parts of the group in a separate container while proceeding with disassembly inspection repair and reassembly of ponent groups mended ATF T–IV 2 All disassembled parts should be washed clean and any fluid passages and holes should be blown through pressed air 3 Dry all parts pressed air–never use shop rags 4 When pressed air always aim away from yourself to prevent accidentally spraying ATF or kerosene on your face 5 The mended automatic transaxle fluid or kerosene should be used for cleaning 6 After cleaning the parts should be arranged in the correct order for efficient inspection repairs and reassembly 7 When disassembling a valve body be sure to match each valve together with the correspond- ing spring 8 New discs for the brakes and clutches that are to be used for replacement must be soaked in ATF for at least 15 minutes before reassembly 9 All oil seal rings clutch discs clutch plates rotating parts and sliding surfaces should be coated with ATF prior to reassembly 10 All gaskets and rubb
