标准试验方法胶带法测量附着力.doc

Designation：D 3359 – 02
名称： D 3359-02
Standard Test Methods for
Measuring Adhesion by Tape Test1
ASTM D3359-09 原则实验办法 胶带法测量附着力
This standard is issued under the fixed designation D 3359；the number immediately following the designation indicates the year of original adoption or，in the case of revision，the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval.
这个原则是D 3359拟定了后来发行。数字代表名称最初通过时间，或者修订状况，和最新版本。括号内数字代表最新重新审批时间。上标代表最新版本变化或重新审批。
This standard has been approved for use by agencies of the Department of Defense.
该原则已经被国防机构部门批准使用。
1. Scope 范畴
These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-sensitive tape over cuts made in the film.
本原则提出实验办法是规定通过在漆膜切割区施加和撕离压敏胶带方式，对漆膜与金属底材之间附 着力进行评估程序
Test Method A is primarily intended for use at job sites while Test Method B is more suitable for use in the laboratory. Also，Test Method B is not considered suitable for films thicker than 5 mils (125µm).
实验办法A重要是供工作场合用，而实验办法B更适合实验室使用。实验办法B被视为不适合厚度超过 5毫英寸（125微米）漆膜。
NOTE 1—Subject to agreement between the purchaser and the seller,Test Method B can be used for thicker films if wider spaced cuts are employed.
注 1-依照买卖双方合同，如果切割间距较宽，漆膜较厚时可采用实验办法B。
These test methods are used to establish whether the adhesion of a coating to a substrate is at a generally adequate level. They do not distinguish between higher levels of adhesion for which more sophisticated methods of measurement are required.
本原则规定实验办法用于总体鉴定涂层与底材之间附着力与否达到足够水平。如果附着力较高，本原则规定实验办法无法精准地区别附着力差别，需要使用更精准测量办法。
NOTE 2—It should be recognized that differences in adherability of the coating surface can affect the results obtained with coatings having the same inherent adhesion.
注2-应当注意到，涂层内在附着力相似状况下，涂覆面附着性差别会影响测量成果。
In multicoat systems adhesion failure may occur betwe