WLC配置指南.doc

WLC 配置指南 Cisco-WLC 4402 无线控制器配置示例: 启动 Cisco WLC 后必须使用 Window s 中自带软件“超级终端”并通过 console 电缆登陆 WLC 进行配置。随后根据系统提示完成以下配置: System Name [Cisco_40:4a:03]: Enter Administrative User Name (24 characters max): cisco Enter Administrative Password (24 characters max): cisco Service Interface IP Address Configuration [none][DHCP]:none ==== 》这里选择不使用 DHC P 服务来分配服务端口的IP 地址获得方式。我们将手工进行配置。 Management Interface IP Address: Management mask: Management Interface Default Router: Management Interface VLAN Identifier (0= untagged): 10 AP Manager Interface IP Address: AP-Manager is on Management , using same values AP Manager Interface DHCP Server : ======== 》指向核心交换机,由核心交换机负责 DHCP 服务功能。 AP Transport Mode [Layer2] [Layer3]: Layer3 ======= 》选择使用三层传输模式 Virtual Gateway IP Address: Mobility/RF Group Name: mobile-work Name (SSID): secure-P ======== 》 Wlan 的名称 Allow Static IP Addresses [YES][no]: yes ====== 》允许手工配置 IP 地址 Configure a RADIUS Server now? [YES][no]: no ======== 》不配置 Radius Server Enter the RADIUS Server's Address: Enter the RADIUS Server's Port [1812]: Enter the RADIUS Server's Secret: Enter Country Code (enter 'help' for a list of countries) [US]: CN Finally, the corresponding AP Radio types must be configured on the AP, as shown in Example 9 below. In this lab, we will be using radios with transmit power set to 1mw in ord