30–1 DRIVE SHAFT / PROPELLER SHAFT – DRIVE SHAFT, PROPELLER SHAFT, AXLE DRIVE SHAFT, PROPELLER SHAFT, AXLE 3009Z–03 PROBLEM SYMPTOMS TABLE Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts. Symptom Suspect Area See page 5. Wheel alignment 26–5 27–3 6. Steering linkage (Loosen or worn) 51–18 Wander 7. Hub bearing (Worn) 30–17 30–24 8. Stabilizer bar 26–19 1. Wheel balance 2. Shock absorber 26–8 3. Suspension arm lower (Worn) 26–13 Front wheel shimmy 4. Coil spring 26–8 5. Hub bearing (Worn) 30–17 30–24 1. Inbord joint (Worn) 30–6 Noise (Drive shaft) 2. Outbord joint (Worn) 30–6 2004 COROLLA (RM1037U) AuthorĂ: DateĂ: 1266 30–2 DRIVE SHAFT / PROPELLER SHAFT – DRIVE SHAFT, PROPELLER SHAFT, AXLE 300A0–02 ON–VEHICLE INSPECTION 1. INSPECT FRONT AXLE HUB BEARING (a) Remove the front wheel. (b) Separate the front disc brake caliper assy (See page 30–17). (c) Remove the front disc. (d) Inspect the bearing backlash. (1) Using a dial indicator, check the backlash near the center of the axle hub. Maximum: mm ( in.) If the backlash exceeds the maximum, replace the front axle hub bearing. D26919 (e) Inspect the axle hub deviation. (1) Using a dial indicator, check the deviation at the sur- face of the axle hub outside the hub bolt. Maximum: mm ( in.) If the backlash exceeds the maximum, replace the front axle hub sub–assy. (f) Install the front disc. (g) Install the front disc brake caliper assy D26920 (See page 30–17). (h) Install the front wheel. Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf) 2. INSPECT REAR AXLE HUB BEARING (a) Remove the rear wheel. (b) Remove rear brake drum sub–assy. (c) Inspect the bearing backlash. (1) Set a dial indicator near the center of the axle hub and check the backlash in the bear
