冲孔落料正装复合模动画仿真（三维建模CAD图纸）.pdf

冲孔落料正装复合模运动方仿真
摘要
本设计题目为冲孔落料正装复合模运动仿真设计, 体现了带窄凸缘
筒形零件的设计要求、内容及方向, 极有设计意义。通过对该零件模具
的设计, 进一步丰富了本人冷冲模设计的基础知识, 为今后设计更复杂
的冲压模具做好了铺垫并获取了更丰富的经验。
本设计运用冲压工艺及模具设计的基础知识, 首先分析了制件的形状
及生产可行性, 为合理选取冲压工艺方案做好准备; 然后估算了落料毛
坯的体积, 便于排样; 最后分析模具结构, 确定模具的设计参数、设计
要点及卸料装置的选取。
关键词: 冲压模运动仿真动画
The shield blanking and pound dies design
Abstract
The topic of the design is a shield produced pound blanking
and drawing dies, it is according to the requirements , the
contents,a lso the directions of cylindrical part which has a narrow
flange. And it is of great significance. Throughing the die design
of this part, my foundation knowledge of die design was enriched
a lot. It will be helpful for my later's die-designing which are
more difficult, in addition, I have gain countless experience .
The design using blanking technique and foundation knowledge
of die design, first by analysising the shape of the part and
feasibility of producing. All have done are making preparation
for reasonable selection of blanking technique scheme . Then
calculated the volume of the blank flat,so it is simple for layout
designing. Finally anlysised the die structure,confirmed the die
designing parameter , designing essences and selecting tripper.
Keywords:  compound blanking, working process, Inventor Studio
目录
1 冲压模及相关软件介绍...................................... 12
冲压工艺简介与分析...................................... 12
Pro/ENGINEER 简介....................................... 14
Pro/ENGINEER 的特点................................... 14
Pro/ENGINEER 的模块与功能............................. 15
2 动画设计部分.............................................. 20
概述.................................................... 20
动画创建的一般流程...................................... 20
动画创建的过程.......................................... 20
进入动画模块............................... 21
创建动画................................... 22
3 心得与结论..........................