喷涂件质量要求样本.doc

一、 外观质量要求:
喷涂件表面涂层平整光滑、 均匀, 不许可有皱纹、 流痕、 鼓泡、 裂纹、 露底、 发粘等影响使用缺点。
A, appearance quality requirements:
Spraying pieces of the surface coating, should smooth and even, Defects which influence the use, such as wrinkles, flow mark, blister, crack, tacky, and other defects are not allowed.
检验方法:
正常视力, 在正常光线下, 不使用放大器, 将检验产品置于距离眼睛一个手臂远位置十秒钟内观察。
A 表面-产品安装后能够连续看到表面。
B 表面-产品在安装前才能看到表面。
Inspection method:
Normal sight, under normal light, do not use amplifier, put the product in a arm distance position in ten seconds observation.
A surface, the surface which can be seen continuously
after installation.
B surface, the surface only can be seen before installation.
A面:
1．300mm长度范围内, 只许可3个直径≤、 凹坑（不露底）、 鼓泡等缺点; 超出记次要缺点。 许可有1条长度<6mm且不露基材划痕; 6—20mm且不露基材划痕记次要缺点, 超出20mm记关键缺点。 漏基材划伤≤3mm不记缺点; 3—12mm长划伤记次要缺点; 超出12mm记关键缺点。
A Surface
mm length, only allow no more than three spot, which less than or equal mm in diameter, pits (don't show edge), blister etc. defect; if out off requirement ,sighed secondary defects. Allow one scratch, length < 6 mm and do not expose base material; scratch, 6-20 mm length and do not expose base material sighed secondary defects, length over 20 mm sighed primary defects. Scratch, expose base material,less than or equal 3 mm, do not sigh the defects, 3-12 mm length scratches sigh secondary defects; length over 12 mm sigh the