工厂供电系统设计毕业论文.doc

. . -.
XXXVIII
. . 文档.
本科生毕业设计〔论文〕
学院〔系〕：电子与电气工程系
专 业：电气工程及其自动化
学 生：贾 云 鹏
设计〔论文〕题目：工厂供电系统电气局部设计
. . -.
XXXVIII
. . 文档.
本毕业设计为工厂变电所设计，对在工厂变电所设计中的假设干问题：负荷计算，三相短路分析，短路电流计算，上下压设备的选择与校验，变压器的继电保护，变电所二次回路及自动装置，防雷与接地，变电所的过电压保护，计量，无功补偿等几方面的设计进展了述，并对供电主接线的拓扑构造进展了阐述。
该工厂变电所采用10kV单电源进线，采用一台1600kVA的主变压器，最大设备容量1636kW，采用并联电容器进展低压集中补偿，对变压器进展过电流，电流速断，瓦斯保护，按三类防雷建筑物设防，采用强弱电联合接地系统对建筑物进展保护。
在对供电系统短路计算的根底上，进展电力电缆和电气设备的选择设计，同时也对户外平面布置进展了初步的设计。
关键词：工厂供配电，继电保护，防雷与接地，负荷计算
ABSTRACT
This graduation project is designed for the factory transformer substation, to certain questions in factory transformer substation design: the load putation, the analysis of three-phase short-circuits, the short-circuit current putation, the choice
and verification of high and low pressure equipment, the transformer relay protection, the secondary circuit of the transformer substation and the automatic device, anti-thunder and the connection to the earth, the transformer substation overvoltage protection, the measurement, the idle work pensated and so on,All the above aspects and the structure of the power supply host wiring topology have been stated.
The transformer substation with a 10kV single power source coil in it uses 1600kVA main transformer,
. . -.
XXXVIII
. . 文档.
the biggest putation shoulders of which is adopts the shunted capacitor to carry on the low pressure centralism for pensation and sets protection for the transformer by carring on the electric current to it breaking the speed of the flow gas protection, ga