CCNA 2 - Module 11 Exam Answers.docCCNA 2- Module 11 Exam Answers 1. Refer to the exhibit. Router A is correctly configured for OSPF. Which OSPF configuration statement or set of statements was entered for router B to generate the exhibited routing table? * B(config-router)# network area 0 B(config-router)# network area 0 B(config-router)# network area 0 B(config-router)# network area 0 B(config-router)# network area 0 2. Refer to the exhibit. What does the “ O*E2 ″ from the “ O*E2 [110/1] via , 00:05:34, Serial0/0 ″ line represent? *an internal type 2 OSPF route. an external OSPF route at least two hops away. an external OSPF route from two different sources. an external OSPF route that will not increment in cost. a default route. The route was distributed into OSPF from a type 2 router. 3. What does OSPF use to reduce the number of exchanges of routing information works where large numbers of neighbors are present? (Choose two.) root router backup root router domain router backup domain router * designated router * backup designated router 4. Refer to the exhibit. What is the cost of the route to the ? 2110 *1786 5. What does OSPF use to calculate the cost toa work? * bandwidth bandwidth and hop count bandwidth and reliability bandwidth, load, and reliablity 6. What three parameters must be indentical between OSPF routers in order to form an adjacency? (Choose three.) * area id K-values metric value * hello interval * network type interface type 7. Refer to the exhibit. All routers have been configured with the interface priorities that are shown. All routers were restarted simultaneously. The results of the DR/BDR election are shown. What can be concluded about work? Router C cannot win a DR election under any circumstances. If the link for interface goes down, router B will e the new DR. * The highest router ID was most likely det
