万能UPS监控软件下载及说明书.doc

of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of t设定’画面中先设定‘通讯方式’、‘串行通讯端口’后回到主画面中，假设UPS状态区显示‘UPS和电脑联机’即表示已安装成功。〔参阅P8〕
----其他详细的参数设定请参考手册的相关说明----
简 易 安 装 Novell Netware ,v4,x,
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
硬件安装
1、将UPSilon 2000连接线公的一端接在UPS的连接埠上。
2将母的一端接在系统的RS-232通讯口上，假设系统只有25PIN的
通讯端口，可用9PIN对25PIN的转接头来连接。
软件安装
1、由工作站上的Login进入网络系统，此Login的使用者〔User Name〕必须在SYS：SYSTEM目录有读写权限。
F:\>LOGIN SUPERVISOR
2、将UPSilon的磁盘〔或光盘片〕放入A:磁盘驱动器〔或光驱〕中。
3、在磁盘驱动器〔或光驱〕。
A：\>INSTALL<Enter>
4、安装完毕后，请将系统关闭在重新开机，此时系统会将UPSilon. NLM加载并执行。
5、当UPSilon for Netware 被成功的加载系统时，档案伺服机的屏幕会显示成功加载之讯息。您可以ALT+ESC键来切换UPSilon 之屏幕显示。
6、进入UPSilon for NetWare的主页面后，查看在‘UPS Status’的‘Comm. Status’栏，假设显示‘Connect’即表示以安装成功。
7、假设您的系统有一个以上的通讯端口〔Com port〕，‘LOAD AIOCOMX ’指令。
——其他详细的参数设定请参考手册的相关说明——
目 录
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities