铣床操作、维护和保养规程.doc

铣床操作、维护和保养规程
文件编号 版 本:A 铣床操作、
No:MD-WI-016 Version: A
维护和保养规程 实施日期 修改码:0 Regulations on the operation and Date:2011tion of milling tools, spec. Integrit of milling tools shall be checked whether it
is just the right one. And do the utmost to install it to near the machine spindle. Trial-run after
installation. Workpieces must be installed firmly.
6、工作时应先用手进给，然后逐步自动走刀。运转自动走刀时，拉开手轮，注意限位挡块
是否牢固，不准放到头，不要走到两极端而撞坏丝杠;使用快速行程时，要事先检查是
否会相撞等现象，以免碰坏机件、铣刀碎裂飞出伤人。经常检查手摇把内的保险弹簧是
否有效可靠。
6. Feed workpieces manually first, then feeding automatically. Bound board shall be tight enough.
To check whether there is collision when using "fast travel", this is to avoid machine components and
milling tools jump out to hurt person. relief spring inside the handle shall be checked frequently for its
reliable.
7、切削时禁止用手摸刀刃和加工部位。测量和检查工件必须停车进行，切削时不准调整工
件。
7. Do not touch tooling sharp edge and machined parts by hand when slicing,. Machine must be
stopped when measuring and inspect the workpieces. Do not adjust workpieces when milling.
8、主轴停止前，须先停止进刀。如若切削深度较大时，退刀应先停车，挂轮时须切断电源，
挂轮间隙要适当，挂轮架背母要紧固，以免造成脱落;加工毛坯时转速不宜太快，要选
好吃刀量和进给量。
8. Stop feeding milling tools before machine spindle milling depth is too deep, when retreat
milling tools, machine needs to be stopped supply needs to be cut off when changing gear. When
milling raw materials, make sure the