CCNA标准实验06——路由器的基本配置.doc

CCNA标准实验06——路由器的基本配置.docCCNA标准实验06——路由器的基本配置
loopback 1
192. . 1 192.
loopback 2 192. . 1 「0Sel/O 令⑷;| loopback 1 192. . 1
2811 2811
loopback 3 . RouterO Routed
配置路由器RouterO
Router>e n
Router#c onf t
Enter configuration commands, one per line. End with CNTL/Z・
Router(config)#hostname ccna
ccna(config)#int loopback 1 〃配置环回接口 loopback 1
%LINK・5-CHANGED: Interface Loopbackl, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopbackl, changed state to up
ccna(config-if)#ip address
ccn a(c on fig-if)#ex 让
ccna(config)#int loopback 2 〃配置环回接口 loopback 2
%LINK-5-CHANGED: Interface Loopback2, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback2, changed state to up
ccna(config-if)#ip address
ccn a(c on fig-if) #exit
ccna(config)#int loopback 3 //配置环回接口 loopback 3
%LINK-5-CHANGED: Interface Loopback3, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback3, changed state to up
ccna(config-if)#ip address
ccn a(c on fig-if)#exit
ccna(config)#int sl/0
ccna(config-if)#ip address
ccna(config-if)#no shutdown
%LINK-5-CHANGED: Interface Seri a 11/0, changed state to down
ccna(config-if)#clock rate 64000
ccn a(config-if )#exit
ccn a(c on fig)#
ccna(config)#router rip
ccn a