美国罗克韦尔恩泰克.pdf

Technical Data
9000 Series Accelerometers Specifications
Catalog Numbers EK-43781I, EK-43782I, EK-46255I, EK-45890I, EK-43784I, EK-47086I, EK-43792I, EK-47090I, EK-43799I,
EK-43794I, EK-43795I, EK-43797I, EK-43805I, EK-43807I, EK-46496, EK-43811I, EK-43808I, EK-43809I, EK-48958, EK-43786I,
EK-43787, EK-48964, EK-43790I, EK-43791
Topic Page
Typical Vibration Measurement Systems 2
General Purpose Accelerometers 4
High Frequency Accelerometer 5
Low Frequency Accelerometers 5
High Temperature Accelerometers 6
Specialty Accelerometers 7
4…20 mA Accelerometer 7
Intrinsically Safe Accelerometers 8
Accessories 79
9000 Series Accelerometers Specifications
Summary of Changes
This manual contains new and updated information. Changes throughout this revision are marked by change bars, as
shown to the right of this paragraph.
Topic Page
Updated splash proof cable specifications for three-pin sensors 79
Rockwell Automation 9000 Series Accelerometers
Rockwell Automation 9000 Series Accelerometers are general purpose sensors used to measure vibration on industrial
machinery. The family includes a broad selection of sensors with these varied capabilities:
• Low frequency, as low as Hz or 12 cpm
• High frequency, up to 30 kHz or 1800 kcpm
• High temperature, up to 260 °C (500 °F)
• Velocity output, internal integrator
Typical Vibration Measurement Systems
Accelerometers are either permanently mounted or carried from point-to-point in a route-based measurement or analysis
scheme. The entire measurement system, however, can take on a variety of forms, depending on sensor type and the goal of
the monitoring program. The following examples illustrate vibration measurement and monitoring systems.
Figure 1 - XM System and Permanently Installed Accelerometers