2004款丰田卡罗拉自动变速器系统维修手册（英文版） 40-1 AUTOMATIC TRANSMISSION TRANS AUTOMATIC TRANSAXLE ASSY ATM AUTOMATIC TRANSAXLE ASSY Ar to reassembly All gaskets and rubber 0 - rings should be replaced Do not apply adhesive cements to gaskets and similar parts Make sure that the ends of a snap ring are not aligned with one of the cutouts and are installed in the groove correctly If a worn bushing is to be replaced the sub - assembly containing the bushing must also be re placed Check thrust bearings and races for wear or damage Replace if necessary- id Use petroleum jelly to keep parts in place 16 When working with FIPG material you must observe the following Using a razor blade and a gasket scraper remove all the old packing FIPG material from the gasket surface Thoroughly clean all components to remove all the loose material Clean both sealing surfaces with a non - residue solvent Parts must be reassembled within 10 minutes of application Otherwise the packing FIPG ma terial must be removed and reapplied 2004 COROLLA RM1037U 1351 40-2 AUTOMATIC TRANSMISSION TRANS AUTOMATIC TRANSAXLE FLUID ATM AUTOMATIC TRANSAXLE FLUID ATM 400LG-01 ON - VEHICLE INSPECTION 1 CHECK THE FLUID LEVEL HINT Drive the vehicle so that the engine and transaxle are at normal operating temperature Fluid temperature 70 - 80 C 158 - 176 F OK 辻 hot Park the vehicle on a level surface and set the parking brake Add if hot b With the engine idling and the brake pedal depressed shift the shift lever into all ranges from P to L position and return to P position Pull out the dipstick and wipe it clean d Push it back fully into the pipe Pull it out and check that the fluid level is in the HOT posi- tion D25120 If there are leaks it is necessary to repair or replace 0 - rings FIPGs oil seals plugs or other parts 2004 COROLLA RM1037U 1352 40-3 AUTOMATIC TRANSMISSION TRANS PARKNEUTRAL POSITION SWITCH ASSY ATM PARKNEUTRAL POSITION SWITCH ASSY AT
