ZKS008C技术说明书.docx

ZKS008C直流无刷电机控制器
1、概述
ZKSOO8c低压有传感器永磁直流无刷电机驱动器由本公司自主开发完成，采用电机专用控制电路及专用驱动芯片设计。，调速 范围宽、动/静态特性好、保护及时、使用简便。适用于各类低压永磁直流无刷电机: when it connect to GND, the motor running; otherwise, the EN motor is stop.
开关控制：当它接地时，电机运转；反之，电机停止。
brake control: when it don't connect, the motor work up to snuff; whenit connect to the GND, the motor stop at once.
BK刹车控制：当它没有连接时，正常工作；当它接地时，电机立即停止(强烈建议在转速小于lOOOrpm,小惯量负载情况使用)。
speed control input: input voltage is 0〜5VDC or connect directly to the
SV driver' "+6. 25VDC^^ port.
速度控制输入：输入0-5伏的直流电压或者直接接到驱动器+6. 25直流电压端口
speed signal output: when the motor9 pole is "P", the pulse frequency
is 3*P per. Revolutions (OC gate output). (for example, your motor is 8 poles, PG the output signals are 24 pulse/r).
速度信号输出：如电机的磁极是叩”，那么脉冲频率是3*P /转(0C门输出)(例
如，电机是8极的，输出信号是24脉冲/转)。
alarm output: when the driver is alarm statue , the port output lowAj voltage. (OC gate output).
报警输出：当驱动器报警时，接口低压输出(0C门输出)。
6、内部速度控制(Inside speed control)When the SV port input voltage is or 5VDC, the speed can be control by the built-in potentiometer from 0 to the highesto Forward rotating accelerate, reverse decelerate.
，速度可以用内部电位器来控制从0转到最高的转速，电位器顺时针转，加速；逆
时针转，减速。
7、外部速度控制(Inside speed control)When adopt ing outside potentiometer for sdjusting the speed, only link a adjustable potentiometer of above 2k Ohms to SV PIN.
When adopting upper speed giving