手持编程器说明1.doc

手持编程器说明1
The programming that can be used with CPM1A is CQM1 - PROOl or c200h-pro27, which is basically the same.
The command key INS
Address to increase key
0
The CLR clear key
VER school tape machine key
WRITE to WRITE a key, input instructions or data
The address to reduce key
The function of the programmer
The name says
Can work one
Memory to remove
User procedure, PLC system setup, relay, T/C, DM data removal 2
Address set up
Establish the memory address of the program when the program is entered, read, insert, delete, etc
3
The program input
Procedures for input, modification of instructions, and revision of set values 4
The program read
Read the content of the program memory, which can read the broken state of the contact in the mode of operation and monitoring
5
Program checks
Verify that the content of the program conforms to the programming rules, and when there is an error in the program, the wrong address and contents will be displayed
6
Instruction to retrieve
Retrieve the instructions in the program
7
Contact to retrieve
Contact points for each relay, timer/counter specified in the retrieval procedure
Instructions insert
Insert instructions in the middle of the original program
9
Instruction to delete
Delete part of the instruction program in the original program
10
Bit, number, word monitoring
Monitor relay, timer, counter, data store data content
11
Multipoint monitoring
6 or channel monitoring at the same time. The display will only display 3 points at a time
12
Differential monitoring
Check the edge of an OFF ON a contact
Binary monitoring
Each relay, data store, is monitored by channels, which is shown in binary 16~bit format
14
3 words monitoring
Continuous three channels are monitored simultaneously
15
With sign 10 for monitoring
The hexadecimal number represented by a complement of two in the channel is represented by the decimal number with the symbol
16
No sign 10 in monitoring
The transf