CISCO Cisco Networking Academy CCNA Exploration 网络基础知识 CCNA考试模拟试题 《atron: none Adrmnistratne private-vtan mapping, none Operational prrKale-Man none Trurtfong VLANs Enabled ALL Pruning VLANs Enabled: 2-1001 Capture Mode Disabled Capture VLANs Allowed ALL Protected 力Ise Voice VLAN: none (Inactive) Appliance tnjst none 1921681064 26 19216S10J30 R3轲血 p iouie G曲呵 of fast resat is not $d 192 0/24 is vanahly subiifitted, 6sutaets, 2 masks D ![!l(W19545qva 19216^109,00:83 31, S 血10/0 D [WS56] to 19216J1Q9,00:03:31, SoriWQ C 19216?. is Are曲 cotmoied, Sena! 0/1 C 1921611QS/30 is dree石 connected, Sena! 0/0 C 192168JO192/20 is dratly caawc就 FastEtherKt叽 D [9(W19545(S] to 1921^115,:31 Seal 0/1 The path of the packets will be R3 to R2 to Rl. The path of the packets will be R3 to Rl to R2. The path of the packets will be both R3 to R2 to Rl and R3 to Rl. The path of the packets will be R3 to Rl Answer: D Section: Chapter 6: IP Routing Explanation/Reference: 考点：考查EIGRP的路径选择。从R3内网到Rl的路径选择。 链路的带宽一样，很明显是直接从R3到R1。 QUESTION 123 Refer to the exhibit. Switch port FastEthernet 0/24 on AIS witch 1 will be used to create an IEEE trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached? VLANs have not been created yet. An IP address must be configured for the port. The port is currently configured for access mode. The correct encapsulation type has not been configured. The no shutdown command has not been entered for the port. Answer: C Section: Chapter 10: VLAN Explanation/Reference: 由图中画红线的地方可知道接口配置为access模式。 A： vlan没有创建，错误 B： 一个IP地址被配置在端口，错误。 C：端口当前处于access模式，正确。 D：没有配置正确的封装模式，错误。 E：接口没有no shutdown,错误。 QUESTION 124 Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the pri
